Home Copy2-Side Slitting in Multi Tri-Fold.

2-Side Slitting in Multi Tri-Fold.

When Saddle Stitcher SD-513 equipped with Trimmer Unit TU-503 is mounted on this machine, 2-side slitting is applied to all sheets when folded in three.

  • If 2-Side Slitting is combined with Tri-Fold, wrinkles may occur depending on the paper type.

  • If Crease is combined with 2-Side Slitting and Tri-Fold, the part near wrinkles may be broken. In any case, such a problem occurs when the slitting amount is 20 mm or more. If wrinkles occur, reduce the slitting amount.

Menu item

Description

Illustration

[Multi Tri-Fold]

Select [2-Side Slitting] - [ON] on the [Multi Tri-Fold] setting screen.

2-side slitting is applied to all sheets. In this case, only one sheet can be folded. Multi-Fold is not carried out.

  1. Position the original.

  2. Press the [COPY] tab to display the [COPY] screen.

  3. Press [Output Setting].

    The [Output Setting] screen is displayed.

  4. Press [Multi 3-Fold].

    The [Multi Tri-Fold] setting screen is displayed.

  5. Press either [Outside Print] or [Inside Print].

  6. Select [2-Side Slitting] - [ON].

    The 2-Side Slitting screen is displayed.

  7. Specify the 2-side slitting amount.

    Select [(1)] for [Slitting], then press the keypad on the screen, the [] key, or the [] key to enter the slitting amount at the top. Select [(2)], then enter the slitting amount at the bottom in the same way.

    • The difference between the slitting amounts at the top and bottom must be within 10.0 mm.

  8. Press [OK].

    This returns to the [Multi Tri-Fold] setting screen.

  9. Press [OK].

    • To undo the setting, press [Cancel].

    • To disable the function while keeping the current setting, press [Function OFF].
      This returns to the [Output Setting] screen.

    • [Multi 3-Fold] and [2-Side Slit] are highlighted. Pressing [2-Side Slit] allows you to change the 2-side slitting setting.

  10. Press [OK].

    • To undo the setting, press [Cancel].

    • To disable the function while keeping the current setting, press [Function OFF].
      This returns to the [Output Setting] screen.

    • [Multi 3-Fold] and [Crease] are highlighted. In this case, no crease setting can be configured even if [Crease] is pressed.

  11. Press [OK] on the [Output Setting] screen to return to the [COPY] screen.

    An icon representing specified function is displayed under [Output Setting] on the [COPY] screen.

  12. Select additional copy conditions, as desired.

  13. Enter the desired print quantity using the keypad.

    • The sheets folded with 1-sheet-folded in Tri-Fold can be stacked up to 40 sets high in the Multi tri-fold mode tray (paper: 80 g/m2 / 21 lb Bond).

  14. Press Start on the control panel.