Job Reset Setting: Setting the Function Reset Conditions

[Change User]

Specify whether or not to initialize job conditions when the machine determines that the user has changed. When one of the following operations is performed, this machine decides that a user has changed:

- Removing the key counter or copy card

- Pressing Access on the control panel after user/account authentication has been successfully performed

ON, OFF

[ADF Original Direction]

Specify whether or not to initialize the settings currently specified when the original document is loaded into the ADF.

Reset, Not Reset

[Reset Button Function]

Select either the factory default setting (Full Auto) or the desired copy, scan, or store conditions (Initialize) as the default setting to be applied when the machine is reset. Of the Full Auto settings, the finisher mode can be changed in [Finisher Mode when Full Auto] as required.

Initialize, Full Auto

[Mode Memory Auto Call]

Select whether to apply the initial settings configured in [Copy Initial Setting], [Scan Initial Setting], or [Store Initial Setting], or to apply the copy, scan, or store conditions registered in Mode Memory [30], when Initialize is selected via the Reset Button Function. Select [OFF] to resume the former, or [ON] to resume the latter.

ON, OFF

[Finisher Mode when Full Auto]

Specify the finisher function to be used as [Full Auto], when selected in Reset Button Function.

Offset Sort, Offset Group, Sort, Group, Staple Sort, Fold & Staple, Multi Half Fold, Face Up, Face Down

[Initial by Key Counter Insert]

Specify whether or not to resume the initial setting when the key counter or copy card is inserted.

ON, OFF

[Status Hold When Auto Reset]

Specify whether or not to apply the default original glass/ADF mode when the machine is reset.

Keep, Not Keep

[Next Job Staple Setting]

Specify whether or not to deselect the Staple mode automatically when a job using Staple is completed.

Release, Do Not Release

[Original Set/Bind Direction]

Specify whether or not to reset the Direction specified on the [Original Setting] screen and the Bind Direction specified on the [Output Setting] screen after completion of each job.

Release, Do Not Release